Home › Questions › Assignment › ENGR4035 Redesign the delay timer system…

ENGR4035 Redesign the delay timer system of Fig 9.1 using only discrete components (Eg. transistors: Basic Electrical Engineering Assignment, OBU, UK

DADiploma Assignment Help UK Editorial TeamAuthor
3 min read Published
University Oxford Brookes University (OBU)
Subject Basic Electrical Engineering

Assignment brief

Original assignment brief · wording unchanged

Part B: (15%)
Q5. Redesign the delay timer system of Fig 9.1 using only discrete components (Eg. transistors, capacitors and resistors etc, NOT integrated circuits), so your circuit should NOT include a comparator chip. Explain your proposed system. Simulate and explain the performance and limitations of the system. How could you improve on the limitations?

More Same code ENGR4035 Assessment Tasks

Tutors have set other Same code ENGR4035 tasks on this module too. They are listed below so you can see every version of the brief on one page.

ENGR4035 Simulate the system shown in Fig 9.1 using Multisim. Initially set the Variable voltage source VB=1.5V: Basic Electrical Engineering Assignment, OBU, UK

Part A: (30%)
Simulate the system shown in Fig 9.1 using Multisim. Initially set the Variable voltage source VB=1.5V, and ‘open’ the switch and leave it ‘open’. Not an ‘open switch’ is not conducting and a ‘closed switch’ is conducting.

When you open the switch the LED should remain ON, then after a short interval go off. Repeat this sequence by momentarily closing the switch then opening it again. Note that almost instantly the switch is closed the LED comes ON.

Q1. Monitor and record the voltages at pins 2 and 3 of U1, keeping an eye on the LED status. At what voltage on pin 2 does the LED go out? Can you explain why it is no longer ON? Check and record the voltage changes at pin 6 of 741 op-amp (U1) when the LED is ON and OFF.

Q2. Set VB=2V, 4V, 6V and 8V . What happens to the LED for each value and why? Explain what U1 (741 op-amp) is doing?

Q3. The next step is to investigate the current flowing in the transistor (bipolar junction transistor or BJT) Q3. Set the switch to keep the LED OFF and note the values of voltages on Q3 terminals (collector, base and emitter). Now get the LED ON and keep it ON. Measure and record, the voltages across R2 and R4 and calculate the values of IB and IC, these being the base and collector currents respectively. Can you deduce from these measurements the function of Transistor Q3 in the system?

Q4. Go back to the operating conditions needed to get the timer to work for a relatively short time interval and generally probe and record voltages throughout the circuit to see exactly what is happening and try to come up with a brief explanation of how the timer operates.
Explain the operation of the Delay Timer System of Fig. 9.1. Discuss the and explain the performance and limitations of the system. Suggest how could you improve on the limitations?

Unsure How the Basic Electrical Engineering Brief Will Be Marked? Ask a UK TutorWhatsApp us

Unlock success at Oxford Brookes University (OBU) with our specialized Case Study Writing Service UK and convenient online assignment writing service! For ENGR4035 Basic Electrical Engineering, our experts assist in redesigning the delay timer system using discrete components. Simplify your coursework, pay for expert assistance, and excel effortlessly in your assignment. Choose excellence – choose our dedicated support.

Answer
Get Expert Help with Your AssignmentTried AI and still stuck? Get help from a UK tutor – free quote, no obligation.

Tell us about your assignment and deadline, and a UK subject expert will send you a free, no-obligation quote.

Your details stay private and are only used to prepare your quote.

Need Help With This Question?

Our expert writers can provide a complete, plagiarism-free solution tailored to your requirements.

WhatsApp us